Beoworld

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
March 24, 2024 at 11:44 am in reply to: Guidance on Masterlink system with 10 link rooms #31570
steelpan
BRONZE Member
- Topics Started 0
- Total Posts 5
Thanks for the information: by adjusting the timing between the two presses of “menu” I could indeed get into the test menu. 00 then showed “sw: 2.0”.
March 23, 2024 at 11:02 pm in reply to: Guidance on Masterlink system with 10 link rooms #31553
steelpan
BRONZE Member
- Topics Started 0
- Total Posts 5
When I press Menu it activates the timer with display “On 0:00”.

Serial No: 18352475

the document with the MLGW compatibility is attached. You can find it on the site http://mlgw.bang-olufsen.dk/source/documents/
March 23, 2024 at 4:03 pm in reply to: Guidance on Masterlink system with 10 link rooms #31516
steelpan
BRONZE Member
- Topics Started 0
- Total Posts 5
I removed it from the wall and the type plate shows sw: 2.0 Type No:1601.

Is there a way to update the sw to version 3.3 as needed to reroute the light/control commands?
March 23, 2024 at 3:47 pm in reply to: Guidance on Masterlink system with 10 link rooms #31512
steelpan
BRONZE Member
- Topics Started 0
- Total Posts 5
Hello,

It is in a working setup with BS5 as audiomaster and a beolink converter NL/ML as videomaster to get access to my Beovision Avant 55 MKI.

All commands seem to work properly.
March 23, 2024 at 2:49 pm in reply to: Guidance on Masterlink system with 10 link rooms #31508
steelpan
BRONZE Member
- Topics Started 0
- Total Posts 5
Hello,

I would like to reroute the light commands from my BL3500 to my Beolink Gateway which is only working from sw version 3.3.

I tried to find out the sw version of my BL3500 (from 1994) but neither combination (“Menu Menu 00 go” or “Menu 00 go” worked. Any idea what can cause this?

Kind regards,

Luc
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)