Pindsen

Forum Replies Created

Viewing 41 post (of 41 total)
1 2 3
  • Author
    Posts
  • May 2, 2022 at 9:24 pm in reply to: Beolab 5000 Type 5303 #4639
    Pindsen
    BRONZE Member
      • Denmark
      • Topics Started 16
      • Total Posts 57

      Hi,
      Yes of cause, now I get it 🙂
      Then I have three more questions:

      1. When I apply a line signal to TAPE I have sound in speakers, but when I apply the same line signal to either the TUNER or AUX there are no sound. I have tried to follow the schematic but it just a lot of switches – any idea?
      2. There are adjust knobs in the bottom and also High/Low switches – It is mentioned in the service manual but I can’t find how to adjust the knobs, is it just by ear? – any idea?
      3. I have low light in the bulbs and at test point BP I only measure 25,5V (60V is expected). I have tried to turn the potentiometer 457 but no change, it is steady at 25,5V. Before moving on I would to hear any ideas?

        /Pindsen

    • Author
      Posts
    Viewing 41 post (of 41 total)
    1 2 3