[Sy Ben]

citronix wrote:

Well – I made it so far, that when I disconnetc the P26 – the 8 pin plug on PCB 11 – the DAC, the autocalibration turns of after been engaged for about 10 seconds – which seems correct. But why – I still dont know I have tried to replace PCB 11 and 13, one at a tim, with PCBs from a working machine – without any changes ;-(

I think the device is not functioning correctly logically. After performing REC CAL, the values will not be accurate

[Sy Ben]

Yesterday, I had some free time and checked my equipment. I found that 13IC3 was short-circuited. I replaced it with a similar IC, and everything is back in operation. There is still another issue with EQ and sensitivity that I will continue to investigate when I have the time.

[Sy Ben]

chartz wrote:

Hi, Or the Terminal 8000, of course. But no stepped volume drops or reset! But it does work fine. Jacques

Thank you, I have a slightly off-topic question. My device operates on 120V power, is there any way to switch it to 220V by changing the power transformer?

[Sy Ben]

Dillen wrote:

Beolink 7000 does not operate Beomaster 6000. You will need the Terminal 6000. https://www.beoworld.co.uk/prod_details.asp?pid=994 Martin

Thank you, I think I will look for the Terminal 6000 for synchronization 🙂

[Sy Ben]

I just checked, all the cable connections are fine, and there are no issues there. I believe the problem lies with the IC (Integrated Circuit). I am contemplating whether to get the IC from China, which may offer faster delivery, but the quality might be inferior.

[Author]

Posts