Beoworld

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
July 10, 2023 at 7:59 am in reply to: Beogram 3000 5901, motorcontrol schematic #22042
on4dag
BRONZE Member
- Topics Started 2
- Total Posts 7
Hi Mark,

thank you for your remark. I have seen some posts on this topc and I am thinking of doing this (“oil-vacuum”) as well. But first I had to check if the other parts were all doing well.

Thanks for your help.
July 9, 2023 at 4:48 pm in reply to: Beogram 3000 5901, motorcontrol schematic #22026
on4dag
BRONZE Member
- Topics Started 2
- Total Posts 7
Thanks all for your help.

I have a question on the main bearing (nylon fitting) but I will make a new topic / post
July 9, 2023 at 9:02 am in reply to: Beogram 3000 5901, motorcontrol schematic #22011
on4dag
BRONZE Member
- Topics Started 2
- Total Posts 7
I have reinstalled and motor is functioning!

Motor makes still some noise, from the brushes. So I have to look if these are still available.
July 9, 2023 at 7:47 am in reply to: Beogram 3000 5901, motorcontrol schematic #22009
on4dag
BRONZE Member
- Topics Started 2
- Total Posts 7
Hi Mark,

I had a blown fuse and only the motor module caused this.

I have tested the motor and it runned but with noise. Now I have re oiled the bearings but didn´t test the whole again. Can dry bearings cause an overcurrent to blow the fuse? If so, then I have to install it again and test it. What is your experience?
July 8, 2023 at 1:03 pm in reply to: Beogram 3000 5901, motorcontrol schematic #21997
on4dag
BRONZE Member
- Topics Started 2
- Total Posts 7
Some photos of the situation.
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)