Moonlight70

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • February 9, 2024 at 2:35 pm in reply to: Beogram 1202/1203 – Noise from idler wheel #29589
    Moonlight70
    BRONZE Member
      • Topics Started 2
      • Total Posts 4
      Dillen wrote:

      ……The motors metal bracket must not touch the nylon bushings ……… Martin

      Thanks Martin! I think the problem were there. The nylon bushings appeared to be fitted in the wrong order, so the opening space was too low. I compared with the quiet one.

      January 5, 2024 at 4:17 pm in reply to: Beogram 1202 Pickup gap #28245
      Moonlight70
      BRONZE Member
        • Topics Started 2
        • Total Posts 4

        Thanks Geoff! I will take a look at the pickup. I did set it to 2g, but I am not sure if it is SP10 or SP14. I tried to adjust the three screws for the platter-hight, but if I lower the platter, the pickup-arm stand also lowers. So the gap are constant.

        //Lars

      • Author
        Posts
      Viewing 2 posts - 1 through 2 (of 2 total)