[mPartio]

Bonjour Bebopellula.

As far as I can tell the only service menu is:
MainMenu->Setup
press Red button
press Center button

I also have the screen needing to be remeasured due to a circuit board repair/replacement.

Unfortunately, it appears that a separate measuring device from the dealer/installer is required to do this measuring to make the warning “message” at startup go away.

It was designed to have the installer do this measuring when the system was first installed.

I am still waiting to see if there is one still available in North America from my B&O representative to have borrow in order to make that calibration again.

[mPartio]

Steve at Sounds Heavenly wrote:

Hi, This issue shouldn’t occur normally, but several factors can bring it on. Lack of grounding to the digital amps in ICE Power speakers can cause a low frequency mains hum or buzz sound, but this was described as a high frequency buzz in the original post, which sounds like something different…

 

I know this is an older thread but I have the same problem but appears to be a ground hum. Steve can you describe some of those factors you mention or some advice to make sure things are grounded well? I’ve also got a mix of bl3 and BL12-3s with combination of cat 8 and converter dongles driven by a BeoSystem4.

[mPartio]

Thanks Millemissen for confirming. And yes I meant the internal app. I kind of wondered but really thought I saw it try to connect at one point when setting everything up. The Moment has no problem connecting to Deezer so I was optimistic it could still but, as you pointed out, it’s easy enough to link it to the Moment or one of the cores, etc.

[mPartio]

OK, I figured out what must of been a silly question for most of you.

I’ve just switched from a MasterLink-centric network with a few NL products (with converters) to an NL network with a few converted ML products (with converters) and was still thinking through the MasterLink paradigm lens.

I guess I had always thought of the connected products having to deal primarily with integration ( audio-master & video-master) but after setting everything up it’s clear that’s just how you make products visible to each other on the network.

Any integration option is a secondary feature within that.

It’s been a few years.

A lot to catch up on:)

 

 

[mPartio]

I seem to have answered my own question. At least for the customer service menu which is MainMenu->Setup

then:

red + center “go”

Does anyone know if there is a normal service menu (like 0 0 go)

I can’t access one like on the BS3, however it may not exist on this model.

Can anyone confirm?

 

[Author]

Posts