Forum Replies Created
- AuthorPosts
-
No.
Looks more like something from Philips or perhaps subbrand DUX.
Scandyna could also be a bet. Their 1702-1 was quite a rip-off in many ways. Can’t really tell as the platter is not visible.Martin
Thanks, Jacques.
Martin
That PCB needs a full restoration.
It still has the original capacitors, which will be bad by now, and the original, now badly oxidated, trimmers.
With all that still in circuit in can be difficult to point to a specific culprit component.Had the PCB been completely restored, and still failing, the reason could be a leaking diode or transistor.
Martin
For potential takers it would be nice to know where in the world it is located.
Martin
Beomaster 3500 has no timer functions and it doesn’t support two-way remote control.
Martin
September 11, 2022 at 8:14 am in reply to: bang & olufsen beolab penta active loudspeakers mk2 (6623) for sale #8556It would perhaps help, if you’d give us an idea about the the price and where in the world they are to be picked up.
Martin
Currently no less than five for sale at Discogs: https://www.discogs.com/sell/release/12904500?ev=rb
Wow, – now just three left…
Martin
You’re right, thank you for pointing this to me. 9€ shipping for a 3€ record is a bit too much unbalanced to me. Nevertheless, I thought this would be more rare and will keep an eye on Discogs. Thank you Martin.
What if the record was EUR 9 and shipping EUR 3?
Martin
Currently no less than five for sale at Discogs:
https://www.discogs.com/sell/release/12904500?ev=rbI cannot see the shipping cost to France, but I don’t think the asking prices are too bad.
Martin
Why not just find and buy a real one?
Martin
And here the cha-cha.
(Attached)Martin
OK,
Here the march (attached).
No singing.Martin
There’s a march too.
Do you want them?Martin
Katy Bødtger with Deccas Dance Orchestra – B&O Stereomelodien (vals).
(Attached file).Martin
None that I am aware of.
You must take out the drive and rotate the flywheels by hand – or using some kind of suitable tool to carefully push them round.Martin
Good job!
Martin
A bit difficult, and it really depends on which version of drive is fitted in your Beocord.
But basically it’s a matter of rotating the flywheels by hand (Beocord unpowered) until
the tapehead bridge disengages.
Note that the two flywheels rotate in opposite directions; Left one clockwise, right one counter clockwise as seen from above.-And replace belts.
Correct belts here.Martin
Has C7 (220uF) shorted?
Martin
During playback , do you have signal on pin 4 on both Dolby ICs?
What is the DC voltage on pin 5 (Vref) and pin 28?Martin
- AuthorPosts