DanteM
Forum Replies Created
- Posts
-
Anyone knows if the IC304 is the responsible for storing calibration data?
Flashes green only? Looks like it didn’t store the calibration parameters.
Could be a fault in a memory chip in the chassi.
Yes, but my point here is about using other speakers to improve the sound coming from a different speaker.
I think Geoff mention something like this in the past for B&O, but Dirac launched it first?
That’s a great idea! I didn’t think of that before!
I’ve easy access to a guy who paints with powder. Will check on that.
Thanks for the tip!
Regarding Atmos speakers, can’t we use the Beosound Shape on the ceiling?
I’m using a bluetooth receiver with RCA out to connect my Lg to the BL8000.
My TV only have optical and hdmi out, hence the solution.
I had the same problem with my BL5 some years ago. First I thought that the problem was the 96kHz spdif signal, as the BL5 has a 88.2kHz limit written in the manual.
One speaker was fine but the other sounded weird in the tweeter. I found out that when daising chaining the spdif signal, the output from one speaker to the second one is limited to 44.1kHz, even when the original signal in the first speaker is higher.
However, looks like someone updated the eletronics to allow 96kHz input, but forgot to mention that in the manual.
In the end, i found out that the distortion was from bad cable. I was using ordinary analog audio cable, which has good shielding up to 50 kHz signal. As I was feeding 96 kHz signal, lots of distortion came up. The second speaker didn’t show any distortion because the signal was reduced to 48kHz.
So I changed my spdif cable to a digital one and then everything was great.
Steve from Sounds Heavenly can help you with that.
Gluing some basstraps on the corners and praying for wife to allow them…
