Connecting a Beolab 2 to a Beosound 9000 wireless

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • August 23, 2023 at 4:07 pm #23255
    69er
    BRONZE Member
      • Topics Started 16
      • Total Posts 47

      Hi beoworld,

      i am trying to connect an older B&O Speaker (in this case a Beolab2) wireless with a Besosound 9000.
      I found a Beolink1 receiver (WISA), which should output to the switched Powerlink, which is needed for the Beolab 2.

      But what transmitter could be used to run the Besound 9000 as a source for that signal?

       

      Would be thankful for any hint reagrding this problem.

       

      Best regards

      69er

      August 24, 2023 at 9:25 am #23295
      Steve at Sounds Heavenly
      Moderator
        • Topics Started 50
        • Total Posts 364

        Hi 69er,

        You will need the B&O Transmitter 1 connected to the 9000, then a B&O Receiver 1 connected to the Beolab 2. Please use two RJ45 to Powerlink cables for the connections (one for each device):-

        https://soundsheavenly.com/bang-olufsen/31-325-rj45-to-powerlink-compatible-all-in-one-cable-convert-new-2013-ethernet-powerlink-to-traditional-8-pin-din-powerlink.html#/9-length-18m

        Kind regards, Steve.

        August 28, 2023 at 5:25 pm #23465
        69er
        BRONZE Member
          • Topics Started 16
          • Total Posts 47

          Hi Steve,

          thank You very much for your help. Much appreciated.

          Best regards (from a youtube follower – i learnt so much from your videos)

          69er

          August 28, 2023 at 5:32 pm #23466
          Steve at Sounds Heavenly
          Moderator
            • Topics Started 50
            • Total Posts 364

            Thanks 69er!

            Kind regards, Steve.

          • Author
            Posts
          Viewing 4 posts - 1 through 4 (of 4 total)
          • You must be logged in to reply to this topic.