Beomaster 1900-2 help fixing crackly FM

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #30110
    Madelvic
    BRONZE Member
      • Topics Started 1
      • Total Posts 4

      I’m trying to restore a Beomaster 1900-2

      The Phone and Tape inputs work fine, but the FM input on any of the 4 presets or 5th tuner is low in volume and crackles

      So far I’ve changed all of the electrolytic in the Tuner and IF / Stereo Decoder (reference the Service Manual) but to no avail

      Any help would be welcome – I’m basically stuck (and at the limit of my knowledge)

      Many thanks

       

       

       

      #30119
      auric
      BRONZE Member
        • Topics Started 14
        • Total Posts 83

        Have you changed the electrolytic capacitors C201, C202, C203, (and corresponding on right channel)?

        There is also a 10uf cap inside the can.

         

        Derek

        #30122
        Dillen
        Moderator
          • Topics Started 3
          • Total Posts 587

          A bad MPX chip wouldn’t be a first.

          Martin

          #30130
          Madelvic
          BRONZE Member
            • Topics Started 1
            • Total Posts 4

            Thanks Derek. Yes I’ve changed C201, C202, C203 (and the C3xx) plus C23, C20, C99, C27 and recently C18 in the can though not tested it since the last change. C18 was reading about 17uF so working but well out of range. I’ve tested C15 but not changed it.

            Wondering if I should change the transistors- will stress them with cooling spray first if I can

            #30131
            Madelvic
            BRONZE Member
              • Topics Started 1
              • Total Posts 4

              Thanks Martin. Can do, would you recommend before transistor swaps?

              #30157
              Dillen
              Moderator
                • Topics Started 3
                • Total Posts 587

                Yes, I would suspect the IC before any of the small transistors.
                Put a scope to the L/R signals from the IC and you will see.

                Martin

                #30239
                Madelvic
                BRONZE Member
                  • Topics Started 1
                  • Total Posts 4

                  Found and ordered a replacement IC. Update to follow

                   

                Viewing 7 posts - 1 through 7 (of 7 total)
                • You must be logged in to reply to this topic.