Beocord not rewinding or forwarding – here is a solution
- This topic has 4 replies, 3 voices, and was last updated 11 months, 4 weeks ago by
.
- Posts
-
Hi guys,
wthout this forum i could not maintain my B&O hobby, so first of all thank YOU all for the help in the last years!
You should always give back – so here I am.
I struggled a lot with some Beocord 6500 and similar (one large belt drive).
Most often i was healed with a new belt – but even sometimes with new ones, it did not work well. Especially the fast forward and rewind function was not good.
My background is engineering – not that i know, how electronics work – but as engineer you most often don´t give up that easy if an error occurs. And you don´t believe immediately, if it suddenly works and You don´t know why.
So: i found ONE error, for sure not the only one, but the one, which was important for 4 of my beocords.
It was not the belt, it was the little white drive worm on one of the motors.
Look at yours, and when you see a little crack – this is it. It slips then on the shaft. And this stops the whole B&O mechanism.
You need to dismantle the whole piece, clean it with alcohol and the glue it with superglue. Not the slipping stops and the mechanism works how it should.
Of course, cleaning all other stuff and replacing belt is a must, but if it´s not enough – maybe this one is the last step before success.
Happy!!!!
Wish You all a pleasant nicht
69er
Found this post now. Trust me I WILL check this!! Really good post. I hope this helps me and my beocord. I will get back with results!
Thanks a LOT – been trying to find the fault on my Beocord 5500 for ages – but coudnt until i red your post
- You must be logged in to reply to this topic.